TPE roof vents for bituminous membranes

The vent pipe allows moisture and vapour under waterproofing membrane to go out. It is available in the following models: the simple wall version used in case of a simple waterproofing membrane and the double wall version used in the presence of insulating panels. For a further protection, the use of the special protection collar is also recommended.
FEATURES
- Reinforced dome
- Protection collar
- Special ribbing to facilitate the attachment of the cast bitumen
- Anchoring points for the cast bitumen
ADVANTAGES
- EXCEPTIONAL FIRE RESISTANCE
- WIDE FLANGE
- WIDE RANGE OF VERSIONS
Rango completo:

Simple wall TPE roof vent height 225 mm - diameter 62 mm

Simple wall TPE roof vent height 225 mm - diameter 75 mm

Simple wall TPE roof vent height 270 mm - diameter 75 mm

Double wall TPE roof vent height 225 mm - diameter 75 mm

Double wall TPE roof vent height 270 mm - diameter 75 mm

Simple wall TPE roof vent height 400 mm - diameter 75 mm

Double wall TPE roof vent height 400 mm - diameter 75 mm

Maxi simple wall TPE roof vent height 270 mm - diameter 110 mm

Maxi double wall TPE roof vent height 270 mm - diameter 110 mm

Insulated simple wall TPE roof vent height 225 mm - diameter 110 mm

Insulated double wall TPE roof vent height 225 mm - diameter 110 mm

“standard” type air vent for shingles - black

“standard” type air vent for shingles - brick-red

“standard” type air vent for shingles - green

Protection collar

Protection collar